Table of Contents
Table of Contents ......................................2
Precautions ............................................2
Warranty ...................................................2
Safety Information
PRECAUTIONS
Please read and understand this entire manual before
attempting to assemble, install, or operate this light
fixture.
This light fixture requires 120-volts AC.
Some codes require installation by a qualified electrician.
This light fixture must be properly grounded.
This light fixture is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Use a clean glove or cloth when handling the new bulb.
Use isopropyl (rubbing) alchohol to clean the bulb if it is
touched with bare hands.
For proper operation, this light fixture should be:
Installed outdoors to a wall
Installed 8 ft. (2.4 m) above the ground (If the light
fixture is mounted higher than recommended,
aiming the sensor down will reduce the coverage
area.)
Do not leave the "ON-TIME" switch in the "TEST"
position. The frequent ON/OFF cycling of the light
fixture will reduce the life of the bulb
Use only T3 500W (maximum), tungsten halogen
bulb (120 VAC)
Warranty
2-YEAR WARRANTY
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com.
Installation ................................................6
Operation...................................................8
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING: Risk of fire. Do not aim the bulb at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulb at least 2 in.
(51 mm) from combustible materials.
WARNING: Risk of fire. This fixture is designed for wall
mounting only. DO NOT install on a ceiling or soffit.
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from the bulb.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
NOTICE: Do not connect this light fixture to a dimmer switch or
timer.
NOTE: The bulb is included, but needs to be installed. The
bulb is located behind the glass cover of the lamp head.
2