Operation - Defiant DF-5311-BZ-D Guía Para El Uso Y Cuidado

Operation

1
Adjusting the Bulb Holder
WARNING: Risk of fire. Do not aim the bulb at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulb at least 2 in.
(51 mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
CAUTION: Keep the sensor at least 1 in. (25 mm) away
from the bulb.
CAUTION: Keep bulb holder 30° below horizontal to
avoid water damage and electrical shock.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Loosen the lock nut (1) and screw (2) to
adjust the bulb holder (A) for the desired light
coverage. Make sure the bulb holder (A) is
horizontal after all adjustments have been
made.
Tighten the lock nut (1) and screw (2).
NOTE: Do not rotate the bulb holder more than 180° from
the factory setting.
NOTE: The halogen light must be mounted horizontally
(+/- 4°).
1
2
CORRECT
A
A
INCORRECT
Rotating Sensor Controls
2
Downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
C
8