DeWalt DWH052 Manual Del Usuario página 23

All manuals and user guides at all-guides.com
Ensure the bracket, hose and adjustable strap are
completely secured to tool.
Attach Dust Extraction System to
Dust extractor (fi g. 1, 6, 7)
WARNING: Use only power tools
recommended by D WALT with this
E
attachment. For more information about
D WALT power tools compatible with this
E
attachment, please contact your local dealer,
refer to the addresses at the back of the
manual or visit www.dewalt.eu.
Push recommended dust extractor hose nozzle
(i) into connection point (e) until tight. For a more
secure connection use the AirLock connector
system.
NOTE: Ensure hose connection is secure.
AIRLOCK CONNECTOR SYSTEM - DWV9000
(SOLD SEPARATELY)
AirLock allows for a fast and secure connection
between the drilling dust extraction system and the
dust extractor.
1. Ensure the collar (j) on the AirLock connector
(k) is in the unlock position. Align notches (n)
on collar and AirLock connector as shown for
unlock and lock positions.
2. Push the AirLock connector (k) onto the
connection point (e) of the dust extraction
system.
3. Rotate the collar (j) to the locked position.
NOTE: The ball bearings (m) inside collar will
lock into slot (l) and secure the connection.
The drilling dust extraction system is now securely
connected to the dust extractor.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Always read and operate
the tool as instructed in the tool
instruction manual.
1. Turn the dust extractor on as instructed in the
dust extractor instruction manual.
2. Switch on the tool as instructed in the tool
instruction manual.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
TROUBLESHOOTING
FAULT POSSIBLE CAUSE REMEDY
Excessive dust extractor empty the dust
dust is full extractor
emission
filter of dust clean or replace
extractor is the filter
blocked
suction head is replace the suction
defective head
suction channel is clean the suction
blocked channel
dust extraction replace hose
system hose is
damaged
chisel extends for adjust the air inlet
more than 60 mm so chisel extends
25–60 mm
Dust adjustable strap is tighten the
extraction loose adjustable strap
system
adjustable strap replace adjustable
falls off
damaged strap
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
ENGLISH
21