Slave Mode - Cameo FLAT PRO 7 G2 Manual De Usuario

SLAVE MODE

Standard slave mode: Starting from the main display, press MENU to enter the main menu.
Now use UP and DOWN to select the menu item Slave, confirm with ENTER, select Slave Group
0 and again confirm with ENTER. Connect the slave and the master units (same model, same
software version) using a DMX cable, and enable one of the standalone modes on the master unit
(Auto, Static, Color Preset, User Color, Loop). The slave unit will now follow the master unit.
Main display
Advanced slave mode:If you wish to control the slave units in master/slave mode using one of
the Auto or Loop standalone modes, the control signal can be reproduced with a time delay of
up to 24 steps. The delay is set in the sub-menu item Delay in the relevant standalone mode, the
delay factor is set in the slave menu of the corresponding spotlight. This is a simple way to create
a running light effect with a large number of spotlights that are all the same model and have
the same software version. This is otherwise only possible using a suitable DMX controller and
time-consuming programming.
Main display
with group number
and delay time in master unit
Assign the spotlights to one of up to 24 groups according to preference, whereby several spotli-
ghts can be assigned to one group. The group number is also the factor by which the delay time
set in the master unit is multiplied (see setup example).
19