Project Source 51-K814-PS-BN Manual De Instrucciones página 5

INSTALLATION INSTRUCTIONS (Continued)
4. OPTIONAL DECKPLATE INSTALLATION:
The optional deckplate (B) and gasket (C) cannot be
installed with the flange (4.1) on the bottom of the
faucet body (A). Remove the flange (4.1) from the
faucet body (A).
Apply a thin bead of silicone to the underside of the
gasket (C). Place the gasket (C) and deckplate (B) over
the mounting holes in the sink, aligning the center hole
in the gasket (C) and deckplate with the center mounting
hole in the sink. Pull the spray hose (4.2) up through the
faucet body (A) until the end of the hose is flush with the
bottom of the shank (4.3) on the faucet body (A). Do not
pull the fitting on the bottom of the spray hose (4.2) past
the shank (4.3). Carefully insert the water supply lines
(4.4) through the hole in the deckplate (B), gasket (C),
and the mounting hole in the sink until the faucet sits
on top of the deckplate (B).
NOTE: Do not feed the spray hose (4.2) back through
the spout (4.5) and faucet body (A) until step 6.
5. From underneath the sink, secure the faucet body (A) to
the sink using the metal washer (BB) and lock nut (AA).
Secure the lock nut (AA) with the hex bolts (CC).
NOTE: It is helpful to have a second person hold the
faucet in place while tightening the hex bolts on the
lock nut.
Hardware Used
Lock nut
AA
BB
Metal washer
CC
Hex bolt
6. After inserting the tubes (6.1) through the hole in the
sink, pull the spray hose (6.2) back down through the
faucet body (A), and attach the quick connector (6.3)
by screwing it onto the end of the spray hose (6.2) in
a clockwise direction. Hand tighten only.
5
x 1
1
x
2
x
5
4
4.5
4.2
4.3
BB
AA
6
6.3
6.2
A
4.1
4.4
B
C
A
CC
A
6.1