Project Source 51-K814-PS-BN Manual De Instrucciones página 6

INSTALLATION INSTRUCTIONS (Continued)
7. Push the quick connector (7.1) on the end of the spray
hose (7.2) into the quick connect coupling (7.3) on the
quick connect sprayer outlet (7.4). Give the spray hose
(7.2) a tug to ensure the coupling is connected. If it is
necessary to disconnect the spray hose (7.2) from the
faucet, squeeze the tabs on the side spray quick connect
outlet (7.4) and pull down on the quick connector (7.1)
on the spray hose (7.2) to disconnect. After connecting
the spray hose (7.2), attach the weight (D) to the spray
hose (7.2) at the location indicated. To attach the
weight (D), use a screwdriver to detach one side of
the weight (D) from the other. Then connect the two
pieces of the weight (D) back to each other around
the spray hose (7.2).
8. Attach one end of each of the water supply lines onto
the shanks (8.1) on the faucet body (A), with hot water
on the left and cold water on the right. Use 1/2 in. IPS
faucet connections (6.2) or supply line coupling nuts
(8.3) with 3/8 in. OD ball-nose risers (8.4).
NOTE: Do not reuse existing supply lines. When
installing new water supply lines, please refer to the
supply line manufacturer's installation instructions.
Tighten the supply line connections using two wrenches.
Place the first wrench on the shank on the tube (8.1)
to hold it in place while tightening the supply line with
the second wrench. This will help prevent twisting of
the tubing. Do not overtighten. Repeat for the second
tube and supply line. Use caution when tightening the
connections, as the lines can crimp or break, causing
a leak.
9. Attach each of the remaining ends of the water supply
lines (9.1) to the hot and cold shut-off valves (9.2) and
tighten with a wrench. Do not overtighten.
7
Weight
Here
8
8.4
8.3
9
6
A
7.4
7.2
D
8.1
8.2
9.1
9.2
7.3
7.1