Energy Saver - GE AEH24 El Manual Del Propietario

About the controls on the air conditioner.
Lights next to the
touch pads on the
air conditioner control
panel indicate the
selected settings.
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
COOL FAN MODE Pad(s)
Use to set the air conditioner to COOL or
FAN mode.
Temp./Timer Increase
Use to set temperature when in COOL mode,
or the time when using the timer.
FAN Speed Pad
Use to set the fan speed to LOW, MED or HIGH.

ENERGY SAVER

Controls the fan.
ON—The fan will cycle on and off with the
compressor. This results in wider variations of
room temperature and humidity. Normally
used when the room is unoccupied. NOTE: The
fan will continue to run for a short time after the
compressor cycles off.
OFF—The fan runs all the time, while the
compressor cycles on and off.
This feature must be set at OFF in order to
use the fan settings (on the mode control).
Remote Control
s
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
s
The remote control signal has a range of
up to 21 feet.
4
Air Conditioner Controls
v w
/Decrease Pads
Timer
Increase/
Decrease
Pads
Remote Control
CIRCULAIRE
For continuous side-to-side air circulation,
set the Circulaire switch to ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF.
TIMER Pad
ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours
(depending on model) at its previous setting.
Each touch of the TIMER INCREASE v /
DECREASE w pads will set the timer in hours.
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours
(depending on model). Each touch of the
TIMER INCREASE v / DECREASE w pads will set
the timer in hours.
To cancel the timer, press the TIMER pad until
the timer light goes off.
s
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
s
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Temp.
Increase/
Decrease
Pads