Summarize - Baxtran ABS Serie Manual Del Usuario

2. SUMMARIZE

Note: The buzzer sound different when long press or short press the key.
UNIT KEY (Move Key)
A: Select Unit.
B: Status 1: Move the flash on digit to left.
C: Status 2: When all digit flash, press UNIT KEY and let single digit flash, enter into status
1. Press UNIT KEY again enter into status 2. It is circle.
D: Status 3: When set parameter, press UNIT KEY can minus one. (At this moment)
M MENU KEY
A: Press and Hold MENU KEY for 5 seconds will enter into system setting menu.
B: Press and Hold MENU KEY for 1 second will save and quit system setting menu.
C: Short press MENU KEY to alternately display system menu, but if only one parameter in this level, short press
MENU KEY will return to previous menu.
CAL KEY < Enter Key)
When normal weighing, short press CAL KEY will zeroing.
B: Press and hold CAL KEY for 5 seconds will enter into calibration.
C: Enter into submenu.
D: At the bottom menu, press CAL KEY will confirm the present status and return to: (1) The previous menu
(2) Enter into a weighing function (such as density, dynamic)
E: Under COD STATUS ( Engineer Parameter Setting Status) Input different code will enter into correspond para-
meter menu.
Note: Piece counting mode cannot be activated for to calibrate. First, press Tare to exit the piece counting mode.
PRINT KEY (Cycle Key)
When manual printing or communication available, press PRINT KEY will send weighing data to printer or other
equipment.
B: When one digit flash , press PRINT KEY will plus one.
C: Cycle to next parameter when display flash.
TARE KEY (Return Key)
A: Tare.
B: Return to the previous menu without save.
C: Press and hold PRINT KEY for 1 second will quit from a weighing function and retorn to normal weight mode.
(Such as density, dynamic)
USER'S MANUAL ABS EN EN
75