RECARO C 6000 Manual De Montaje página 39

Warning:
The screws in the kit are micro-encapsulated and should never to be used more than once.
The micro-encapsulation will become ineffective if they are repeatedly used and the permanent
securing of the screw connection can no longer be guaranteed.
J
4. Slide the hose/cable harness air connection (3) onto the vehicle connection.
5. Use the closing piece (6) from the kit to seal the venting outlet.
6. Connect the electrical connection (4) up to the vehicle connection and thread it in through the opening.
7. Fit the two half shells that make up the cover (1). Ensure that the air connection (3) is on the right and
the closing piece (6) is on the left according to the direction of travel.
8. Tightly screw the cover onto the vehicle floor using the two cross-head screws (2).
9. Lay the air hose in the direction of the door side rail and then use the cable tie (5) supplied to secure it
to the closing piece (6).
Important note:
The electrical connections for the seat's power supply (plus / minus) must be established by
specialist. See the circuit diagram in Chapter 5.
Whenever the seat is adjusted, ensure that the air hose always lies in the direction of the door side
rail.
Please ensure that the locking device for the cable harness at the side of the seat is underneath
the cover. To check the locking device, the cover must be removed.
10. Activate the express down mechanism.
11. Start the vehicle in order to build up the air pressure needed for the remaining part of the installation.
RECARO Automotive Seating
1 2 3
4
5
6
2
K0264
1 Cover
2 Cross-head screws
3 Air connection
4 Electrical connection
5 Cable tie
6 Closing piece
Page 16 of 23