Carry Handle/S - Casals VC800PELM Manual De Usuario

- To activate it push the Laser
switch 1 time to activate the
laser, 2 times to activate the
light or 3 times to activate both
light and laser.
- To deactivate it complete the
cycle and the 4th time they will
be switch off.
ADJUSTING THE MOVING
BASE – ANGLE CUTTING
(FIG.1)
- The base of this Jig Saw can be
adapted to different angle cuts.
- Use an allen wrench to loosen
the base fixing screws (R).
- Move the base by rotating it.
The base is marked with diffe-
rent angle. Adjust the base to
the angle preferred.
- Fix the screws again.
- NOTE: If you want to cut at
45 degrees, remove the Shoe
protector (H)
LATERAL STOP ADJUSTMENT
- For parallel cutting, use the
lateral stop (U). Cutting width
is adjusted with the scale or
according to the plotting. Tighten
the lateral stop fix screws (G) to
work with the lateral stop.
ONCE YOU HAVE FINISHED
USING THE APPLIANCE:
- Turn the appliance off by relea-
sing start up switch, or in case
you were using lock-on function,
pushing and releasing it.
- Unplug the appliance from the
mains.
- Clean the appliance.

CARRY HANDLE/S:

- This appliance has a handle on
the upper part of the body, which
facilitates comfortable transpor-
tation and usability.
MAINTENANCE AND CARE
- WARNING! Always unplug the
machine before carrying out
work on it.
- Checking the saw blade: depo-
sits of resin and glue on the saw
blade cause inefficient cutting.
To avoid them, always clean the
blade immediately after use.
- The vents should always be kept
clean and free of obstacles.
CLEANING
- Disconnect the appliance from
the mains and allow it to cool
before undertaking any cleaning
task.
- Clean the equipment with a
damp cloth with a few drops of
washing-up liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
- Never submerge the appliance
in water or any other liquid or
place it under running water.