Stopping Work; Sources Of The Compressed Air - Prebena PKT Fillmaster 400 Manual De Instrucciones Original

 Screw cartridges of the compressed air on the joint of the filling valve (6).
 Start up the compressor by pressing the start button (1) and it will begin to work.
The cartridges of the compressor air are already filled. The manometer (5) displays the filling pressure.
Having reached the maximal pressure the compressor is switched off automatically.

It can blow the compressor manually (See p. 16, "Manual Blowing the Compressor").
 Wait for the compressor to be blown automatically.
The reading of the manometer for the filling pressure should be zero.
 Screw cartridges of the compressed air off the thread of the filling valve.
 Screw cartridges of the compressed air off the joint of the compressor.
Now cartridges of the compressed air are filled and ready for work.

Stopping Work

To stop the compressor by full load work do as follows:
 Stop the compressor by pressing the stop button (2).
 Blow the compressor manually as it is written in p. 16 ("Manual Blowing the Compressor").

You can extract the cartridges of the compressed air or

You can go on full load working.
LOOK OUT!
Excessive load can lead to breakdown of the compressor.
Full load work can be gone on only after having blown the compressor. The reading of the manometer for
the filling pressure should be zero.

Sources of the Compressed Air

The compressor works from the sources of the compressed air of Mobilo, Mobilo HD, the sets of cartridges
of KT-3500-S и KT-1500-SY.
The sources of the compressed air of Mobilo and Mobilo HD, the sets of cartridges of the

compressed air of KT-3500-S и KT-1500-SY is a part of the delivery set.
WARNING
Using defective cartridges can lead to explosion.
 Check state of cartridges before every connection.
 Connect cartridges only in irreproachable state.
Preparation of the Compressor for Work
15