Checking Tension Of The V-Belt, Adjusting And Replacement - Prebena PKT Fillmaster 400 Manual De Instrucciones Original

LOOK OUT!
Spilled oil is a dangerous substance for the environment.
 Bind the spilled oil by a binder.
 Gather the bound oil by a duster.
 Recycle the duster accordingly to working legislative directions in the place of use.
 Place a vessel for gathering oil under the compressor.
 Extract the oil level indicator (1).
 Unscrew the screw plug of the hole for draining oil (3) the old oil to run out without rest.
 Let the old oil run out from the compressor aggregate without rest.
 Check if the washer of the screw plug of the hole for draining oil is in a good order (3).
 Screw in the screw plug of the hole for draining oil (3).
 Fill up new oil through a funnel where there is the oil level indicator.
 Check the oil level by the oil level indicator (1).
LOOK OUT!
It is possible breakdown of the compressor because of using unsuitable, polluted or mixed lubricants.
 Use only the special oil of PREBENA Z 200.40.
 Never use insuitable or polluted lubricating oil.
 Do not mix different sorts of oil.
 Recycle used lubricating oils without detriment for the environment.
Checking Tension of the V-Belt, Its Adjusting and Replacement
To check tensions of the V-Belt do as follows:

Remove screws with a spherocylindrical head (1) on the cover (2).
The cover (2) of the protection of the belt (3) is now ready for removing.

Remove the cover (2) from the protection of the belt (3).

Press on the V-belt (4) from above on the centre between the V-belt pulleys (8) and (9) by your thumbs
from below. The V-belt (4) should give at its width at most.
Maintenance of the Compressor
19