Bell HP7 Manual De Instrucciones página 11

1 • Remove the left and right side shield pivot screws using the Hex Wrench, 5/16" or 8mm.
2 • Remove the left and right side SV friction screws using the Hex Wrench, 3/32" or 2.4mm.
3 • Remove the old shield and if necessary replace and install new pivot and friction washers.
New washers have a self-adhesive side to be applied on the helmet shell – make sure the washers do not
cover any of the inserts.
4 • Place the new shield over the well centered friction washers and screw in the pivot screws until snug.
DO NOT OVERTIGHTEN as this may damage the screw threads or pivot inserts. Repeat this procedure on the
other side.
5 • Put the SV friction screw and brake washers back in place.
Adjust the friction tension to the desired level, and then close the shield. Adjustment of the eccentric button
may be required.
6 • Check the action and function of the replaced shield prior to use, assure the installation was correct.
Other Bell models may have a different shield pivot mechanism than the type listed in this manual. Please
refer to bellracing.com if your helmet has a different mechanism or if you need additional assistance.
9