Bell HP7 Manual De Instrucciones página 14

PAINTING
Paint can react with helmet shell and affect its protective capacity. Although the outer shell of the helmet is
constructed of thermoset composite materials and finished with polyurethane coating and although it can
rhetorically be repainted with high quality air drying acrylic or polyurethane enamel, we recommend caution if the
helmet is decorated by an independent painter. Bell acknowledges that helmets are often decorated by
independent painters but there are instances of helmets being damaged during the painting process.
WARNING Paint penetrating into the interior of the helmet can affect the performance of the helmet liner
and other components. In no case(s) should the helmet be dismantled during painting or should paint that
requires heat curing be used. Only paint your helmet once you have determined your proper size. Custom painted
helmets cannot be returned or exchanged. Custom paint services are available through Bell Racing and specific
information is available on the Bell Racing website.
HEAD AND NECK RESTRAINT ANCHOR HARDWARE
Select Bell models come equipped with anchor hardware for specific head and neck restraint systems.
Bell models homologated to certain Snell, SFI, and FIA standards have M6 terminal hardware installed in the
shell and have been tested and homologated so they are compatible with approved head and neck restraint
device anchor systems. If the Bell model you select does not have M6 terminal hardware installed in the shell or
is not pre-drilled for anchor installation, it is not compatible for use with a head and neck restraint device. The
proper installation and selection of the head and neck restraint device anchor system is the responsibility of the
consumer and they assume all risks.
12