Bell HP7 Manual De Instrucciones página 8

TO REMOVE THE HELMET
To remove your helmet, unfasten the chin strap by pulling the red "D" ring tab outward (away from your face) to
release the strap tension. See Illustration 4.
To remove your helmet, grasp the chin strap halves in each hand and while pulling outward, lift the helmet from
your head. See Illustration 1. Pull outward and lift from your head.
Step 4: TEST DRIVE
Steps 1 through 3 are critical to getting the most out of your helmet.Spend as much time as necessary to satisfy
yourself that you have a good fit. Only after successfully completing steps 1 through 3, put on your helmet and
wear it for an extended period or take a test drive. If the helmet feels comfortable, remaining firmly in place and
the straps remained properly adjusted, your helmet is ready to use. If the helmet feels uncomfortable or moves
excessively, go through steps 1 through 3 as necessary to correct the problem. If you are unable to successfully
complete all 3 steps, or if the helmet does not fit and feel comfortable, DO NOT continue to use the helmet.
Either: Return to the dealer for assistance, or contact Bell Racing for further instructions.
Do not use chin cups or wear the strap on the point of the chin. This will increase the risk of the helmet coming
off in an accident.
OPERATION & REPLACEMENT OF FACE SHIELDS
OPERATION
The shield should be opened by placing the thumb of your left hand against the left side edge of the shield
(some Bell shields have a molded in flare or tab, others may not) and simultaneously lifting upward on the shield
to lift it over the adjustable eccentric button. Practice several times to become familiar with this operation before
actual use. To close, simply push downward on the top center of the shield until it comes down as far as possible
and snaps into place over the eccentric button. Always check to be sure it has locked in place over the eccentric
button.
6