Tool Specifications; Noise/Vibration Information; Declaration Of Conformity - Würth STP 140 EXACT-S Traducción Del Manual De Instrucciones De Servicio Original

Tool Specifications

The tool specifications of the machine are listed in the table on
page 192.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries, these
values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product
described under "Tool Specifications" is in conformity with the
following standards or standardization documents:
EN 60745 according to the provisions of the directives
2009/125/EC (Regulation 1194/2012), 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, PFW,
Reinhold-Würth-Straße 12-17
74653 Künzelsau, Germany
T. Klenk
General Manager
Künzelsau: 26.09.2013
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Inserting the Saw Blade
Ejecting the Saw Blade
Switching on the sawdust blower
device
A. Kräutle
General Manager
Mounting and Operation

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 192.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or insertion tools or
is poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
Page
193
193
193
14