Tools Needed - BIG ASS FANS Essence Guia De Instalacion

4
Parts included (cont.)
Note: Drawings below are not to scale.
Cover Plate Assembly
Controller Input Cable
Fire Relay Kit

Tools needed

Big Ass Fans recommends gathering the following tools prior to beginning installation.
Mechanical installation
Standard and metric wrench sets
Standard and metric socket and ratchet sets
Torque wrench capable of 29 ft·lb (39.3 N·m)
Phillips and flat head screwdrivers
Standard and metric Allen wrench sets
Metric Allen head sockets
Drill
Hacksaw
Level
Tape measure
All manuals and user guides at all-guides.com
Pre-Installation (cont.)
Electrical
Wall Controller
Power Supply Cable
1
RJ45 Adapter Cable
3
Snap-on Ferrite Core
(Bagged)
6
WWW.BIGASSFANS.COM
ESSENCE
®
(8) Winglet
2
1. Includes a fan status LED and a switch used to change the
direction of fan rotation. The LED will flash an error code if
there is a problem with the fan. See page 42 for information on
the fan status LED. See page 36 for information on changing
the fan direction.
2. Length = 20 ft (6.1 m).
3. Length = 20 ft (6.1 m). The controller input cable must be
4 wired to the provided RJ45 adapter cable. See "Wiring the
Fan" on page 29 for details.
4. A customer-supplied CAT5 cable must be connected to the
adapter cable and routed to the wall controller. See page 30
for details.
5. Airfoils can be purchased with winglets (standard) or airfoil tips
(optional). Winglets or airfoil tips are installed on the airfoils
during airfoil installation.
6. Attach the snap-on ferrite core to the controller input cable
within 1 ft (305 mm) of the top of the extension tube to
minimize electrical noise.
Electrical installation
Phillips and flat head screwdrivers
#10 to #14AWG strippers
Medium size channel locks
Multimeter
©2013 DELTA T CORP. ALL RIGHTS RESERVED
Airfoils
(8) Airfoil
or
(8) Airfoil Tip
5
(8) Airfoil Retainer
5