3A. Attach Upper Mount (To Angle Irons) - BIG ASS FANS Essence Guia De Instalacion

3a. Attach upper mount (to angle irons)

Secure the upper mount (with extension tube and upper mounting brace already attached) directly to the angle irons using the Mounting
Hardware as shown. Consult the diagrams below for distances between the angle irons. Tighten the hardware so that it is snug, but
do not torque.
Proceed to step 5.
Mounting Hardware (BAF-Supplied):
a. (4) M10 x 40 mm Hex Head Cap Screw
b. (8) M10 Flat Washer
c. (4) M10 Nylock Nut
5 1/2" (13.97 cm)
Note: Dashed lines represent angle irons.
All manuals and user guides at all-guides.com
ESSENCE
Hanging the Fan (cont.)
WWW.BIGASSFANS.COM ©2013 DELTA T CORP.
®
If the hardware is stainless steel, do not use power tools!
a
b
b
c
ALL RIGHTS RESERVED
Side View
17