Sensor Setup - BALDR B0359WST2H2R Manual Del Usuario

2. Insert 2 x AA batteries in each sensor matching the polarity
(+and-);
3. Replace the battery cover.

SENSOR SETUP

●
Switch the Channel 1-2-3 of the senor to any channel you want.
For example, you can set to Channel 1 for the sensor. But please
ensure the main unit are set to the same channel before synchro-
nization. Special note: Press "▲/ CH" button on the main unit to
set the channel. The setting order is CH1--CH2--CH3-- Channel
scan(from CH1 to CH2 to CH3, 10 seconds intervals),you must
select the same number choices for both the sensor and the main
unit in order to synchronize.
● Power the main unit prior to load the battery of sensor.
● Press the "SET" button to switch between Celsius and Fahrenheit.
Notes:
1.
Main unit will auto receive outdoor signal after power on, the
receiving status will last for max 3 minutes. The receiving anten-
na signal will flash. If no signal received in 3 minutes, it will stop
receiving outdoor signal.
2. If the main unit is out of 3 minutes' signal receiving window, you
need to press and hold the "▲/ CH " button to enter signal
receiving again.
MAIN UNIT SETUP
When power on or reset, LCD will full display for 3 seconds with "BI"
sound. Then display Indoor temperature and humidity with 100%
backlight brightness.
8