Maintenance And Service - Bosch PLL 5 Manual Del Usuario

All manuals and user guides at all-guides.com
OBJ_BUCH-311-007.book Page 23 Tuesday, May 6, 2014 1:30 PM
projects out. Pull off the second protective foil () and firmly press
the wall holder with the adhesive tape strip against the structural sur-
face () for at least five seconds. To remove the wall holder, pull out
the adhesive tape strip by the projecting end slowly and as parallel as
possible to the structural surface ().
– Fastening with Pins (see figure H): With the pins 2 provided, the wall
holder can be fastened to drywall or wooden walls. Insert the pins
through the openings in the wall holder as shown in the figure.
– Fastening with a Screw: Place the wall holder 1 via the opening on the
back side onto a screw that projects lightly out of the wall.
– Fastening with Adhesive Tape (see figure I): The wall holder can also
be fastened with commercially available adhesive tape (not included in
the delivery scope) as shown in the figure.
For all four fastening methods, pay attention that the wall holder 1 is fas-
tened securely to the structural surface. Faulty measurements can result
when the wall holder slips away.
Attach the measuring tool via the magnets 14 onto the metal plate 3 of the
wall holder 1.
Belt Clip
With the belt clip 5, the measuring tool, as an example, can be hooked to
a belt and is always at hand.

Maintenance and Service

Maintenance and Cleaning
 Check the measuring tool each time before use. In case of visible
damage or loose components inside the measuring tool, safe function
can no longer be ensured.
Keep the measuring tool clean and dry at all times to ensure proper and
safe working.
Wipe off debris using a moist and soft cloth. Do not use any cleaning
agents or solvents.
Bosch Power Tools
English | 23
1 609 92A 0JK | (6.5.14)