Safety Notes To The Eo2-Form Assembly; Eo Tube Fittings Are Safe High-Pressure Connections; General Safety Notes - Parker EO2 – FORM F3 Manual De Instrucciones

Tabla de contenido

Publicidad

4.4 Safety notes to the EO2-Form assembly

4.4.1

EO Tube Fittings are Safe High-Pressure Connections.

A carefully assembled EO fitting will provide a sealed joint until the tube bursts. Experience has shown
that break-downs, tightening-up and leaks can be avoided by following the safety instructions. Please
check your fitting procedures.
4.4.2

General Safety notes

EO tube fittings are intended for connections for fluid applications solely.
Observe tube recommendations. Non-standard materials or tolerances lead to incorrect fitting.
Do not use bearing balls, fitting pins or tapered pins instead of EO plugs (VKA) as blanking
parts for 24º cones.
Do not assemble progressive rings and functional nuts on selfmade standpipe stud ends.
There is a risk of false assembly with the result of connection shear under load.
The use of steel cutting rings for stainless steel tubes or other unauthorised tool combinations
leads to incorrect assembly.
Tube connection and fitting body once assembled, should remain together. Fitting body is to
be used only once for preassembly.
Air bleeding of tube fittings which are under pressure can be lethal.
Tube under tension can lead to vibration failure. Tube length and bend angles are to be
adhered to precisely. Fix tube lines with tube clamps.
- 33 -

Publicidad

Tabla de contenido
loading

Tabla de contenido