Bk6500/A/C Power Supply Inspection And Set-Up; Assembling The Charger; Charging The Bk6500 - Snap-On BK6500 Manual De Instrucciones

BK6500 A/C Power Supply Inspection & Set-Up
Always wear eye protection to protect your eyes
against dirt and other foreign objects. Follow
operating instructions to reduce the risk of injury
from electrical shock.
Daily, before use, inspect the BK6500 and A/C
Power Supply and correct any problems. Set up
charger according to these procedures to reduce
the risk of injury from electrical shock, fire, and
other causes and prevent tool and system damage.
Before using the BK6500 for the first time, allow
it charge for at least 5 hours to ensure that the
batteries are fully charged.

Assembling the Charger

The charger is supplied with a selection of adaptors
for use in multiple countries. Before first use, select
the appropriate adaptor for your country and attach
it to the charger (Figure 2).
Figure 2: Assembling the Charger

Charging the BK6500

1. Remove the silicon rubber cover from the top
10
Digital Video Scope
of the BK6500 and
insert the External
Power Supply
connector into the
mini USB socket.
Figure 3:
Charging the
BK6500
2. Ensure that the
correct adapter
is fitted into the
Snap-on
charger and insert the charger into a suitable power
output. The LEDs on the Viewer and Imager Handle
will indicate the charging status as follows:
CHARGE STATUS
Not Charging
Pre-Charge
Charging
Fully Charged
Note: The BK6500 will only charge the battery if
the temperature is between 0°C and 45°C (32°F
and 113°F). Outside of this temperature range the
BK6500 may continue to operate but the batteries
will not charge and the Charge Status LED will be off.
1. Make sure the charger is unplugged. Inspect
the power cord, charger and battery for
damage or modifications, or broken, worn,
missing, misaligned or binding parts. If any
problems are found, do not use charger until
the parts have been repaired or replaced.
2. Clean any oil, grease or dirt from the equipment
as described in the Maintenance section,
especially handles and controls. This helps
prevent the equipment from slipping from your
grip and allows proper ventilation.
3. Check to see that all warning labels and decals
on the BK6500 and A/C Power Supply are
intact and readable.
4. Select the appropriate location for the A/C
Power Supply before use. Check work area for:
– Adequate lighting.
– Flammable liquids, vapors or dust that may
ignite. If present, do not work in area until
sources have been identified and corrected.
The charger is not explosion proof and can
cause sparks.
– Do not use the device in wet or damp areas.
5. With dry hands, plug the charger into the
appropriate power source.
6. When the battery is fully charged, the red LED
is replaced by a green LED.
– Once the battery is charged, it may remain
plugged into the charger until it is ready to
be used. There is no risk of over-charging
the battery. When the battery has been fully
charged, the charger automatically switches
to retention charging.
LED STATUS
LED is OFF
LED is Amber
LED is Red
LED is Green