Image Transfer To Computer Using Usb; Transportation & Storage; Maintenance Instructions; Service And Repair - Snap-On BK6500 Manual De Instrucciones

The BK6500 will accept a Micro SD card (not
supplied) for storage of pictures or video.
use, ensure that the BK6500 is switched off and
carefully insert the card fully into the BK6500 as
shown (Figure 20) :
Figure 20: Installing an SD Card
Video Out
The BK6500 can direct the viewer display to an
external NTSC/PAL video display. To use this
feature, a standard 3.5mm jack plug to RCA plug
cable is required. Fully insert the 3.5mm jack plug
into the BK6500 video-out connector and connect
the phono plug to the desired video display device.
Inserting the 3.5mm jack plug disables the BK6500
LCD display and touchscreen.
Note: While the video out cord is plugged in only
live view feature is supported. Pressing the capture
button will take a still picture regardless of mode.

Image Transfer to Computer using USB

The BK6500 can be connected to a PC to transfer
image and video files using the supplied USB
cable; insert the small connector into the BK6500
and the larger end into a computer. Depending on
the operating system , the computer may inform the
user that a device is attached.
The BK6500 will appear as an external drive to the
user allowing pictures and videos to be transferred
to and from the BK6500. Note that if a Micro SD
card is inserted, only those files on the Micro SD
card will be available.
For still images with audio captions, two files must
be transferred to the same folder. These files will
have a common filename with the following two
extensions: .avi .jpg
18
Digital Video Scope
Transportation & Storage
To
1.
2.

Maintenance Instructions

The Snap-on visual inspection device has been
designed to require little maintenance. However, in
order to maintain its performance, you must al ways
follow these guidelines:
1.
2.
3.
4.
5.

Service and Repair

repair center locations (see "Snap-on Service
Center Locations" on page 20). All repairs made
by Snap-on service facil ities are warranted against
defects in material and workmanship.
If you have any questions regarding the service or
repair of this machine, please call or write to one of the
eight service centers (see "Snap-on Service Center
Locations" on page 20) that is most convenient
to your geographic location. Web site: http://buy1.
snapon.com/snapon-store/customer.asp
User serviceable repair parts
BK8000-1
BK8000-4
BK8000-5
BK6500-5
BK5500-8
BK6000-12
Snap-on
Avoid exposing the unit to continuous vi bration
or extreme hot and cold temper atures.
Always store the visual inspection device
in doors in the case it came with.
Always handle the device with care. It is not
shock-resistant and should not be banged
or dropped. Treat it as you would any other
sensitive optical device.
Always clean the imager head after use with
soap or mild detergent.
Use only alcohol swabs to clean the connections.
Avoid rubbing too hard on the LCD. After use,
wipe the display clean gently with a dry cloth.
Do not disassemble this device beyond what is
shown in the manual. Doing so will void
your warranty.
Tool should be returned to the appropriate
36" long, 8.5mm diameter,
9-pin dual view imager
Blow Molded Case
Magnet Retrieval tool
External Power Supply with
international adapters
Composite Video Out Cable
USB Cable