Tool And Work Area Set-Up; Operating Instructions; Using The Imager - Snap-On BK6500 Manual De Instrucciones

Tool and Work Area Set-Up

To prevent serious injury, proper set-up of the
tool and work area is required. The following
procedures should be followed:
1 Review General Safety Information sec tion of
this manual (see page 5).
2. Check work area for: adequate lighting,
flammable liquids, vapors or dust that
may ignite.
3. Follow tool set-up according to specific tool
operator's manual.

Operating Instructions

Do not use excessive force to in sert or
bend the cable.
Do not use the cable or imager head
to modify surroundings,
clogged areas, or as anything other than an in-
spection device.
The Display Unit and imager handle
are not water resistant. The imager head and its
cover ing are water resistant, but are not acid-
proof or fireproof. Petroleum-based products will
ruin the imager cable's protective plastic covering
over time. Avoid submersing the imager head into
corrosive, oily places.

Using the Imager

To display images from the Imager on the Viewer
Unit, it must first be powered on. .
Figure 7: Using the Viewer Handle
12
Digital Video Scope
clear pathways or
Snap-on
1. Capture Button
2. Power ON Indicator
3. Increase Imager LED brightness
4. Power ON Indicator
5. Decrease Imager LED brightness
First, ensure that the imager camera is correctly
attached to the Imager Handle (see Assembly
instructions). The Viewer Unit is switched on and off
by pressing the ON button, the Green LEDs on the
imager handle will illuminate to indicate that the unit is
on. For viewing in reduced light conditions, the imager
camera includes a high-power LED for illuminating
objects. Adjust the LED light output for optimum
viewing conditions by using the LED + and LED –
buttons on the Imager Handle. Note that the buttons
will auto-repeat if held for greater than half a second.
Figure 8: Using the Viewer Unit
1. Touch Screen Display
2. Charge Status Indicator
3. Power Button
4. Microphone
To conserve batteries, the system will automatically
switch off 20 minutes after the last button press.
The current status of the battery is displayed on
the Display Unit display. Note the default time of
20 minutes is configurable using the Viewer Unit
TOOLS Menu.
Using the Viewer Unit
The Viewer Unit performs a number of functions:
• Display and capture live images from the
Imager Handle as stills or video
• Select the video source on the supplied Dual
View Imager camera (front or side)
• Play-back captured images and video