Bosch GCM 12 GDL Professional Manual Original página 41

All manuals and user guides at all-guides.com
OBJ_BUCH-1360-003.book Page 41 Wednesday, November 11, 2015 2:13 PM
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Floor strip/moulding
Inner corner Horizontal mitre angle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located ...
Outer corner Horizontal mitre angle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located ...
Ceiling Strips/Mouldings (According to US Standard)
To cut ceiling strips/mouldings facing flat on the saw table, the mitre angle must be set to 31.6° (saw
52°
table must be turned left or right) and the bevel angle must be set to 33.9° (glide arm tilted left or right).
The following table includes information on sawing ceiling strips/mouldings.
38°
Settings
Ceiling strip/moulding
Inner corner Horizontal mitre an-
gle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located ...
Outer corner Horizontal mitre an-
gle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located ...
Bosch Power Tools
Placed
against the
fence
Left side Right side
45° left 45° right
0° 0°
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
45° right 45° left
0° 0°
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
Placed
against the
fence
52°
Left side Right side
45° right 45° left
0° 0°
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
45° left 45° right
0° 0°
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
English | 41
Lying flat on
the saw table
Left side Right side
0° 0°
45° left 45° right
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
0° 0°
45° right 45° left
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
Lying flat on
the saw table
Left side Right side
31.6° right 31.6° left
33.9° left 33.9° right
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
31.6° left 31.6° right
33.9° right 33.9° left
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
1 609 92A 285 | (11.11.15)