Setting Up And Using The Port Replicator - Toshiba Hi-Speed ​​Port Replicator III Manual Del Usuario

Setting up and using the port replicator

Make sure that the AC adaptor is always connected
while using the TOSHIBA Hi-Speed Port Replicator III
180W/120W. Otherwise the Port Replicator will stop
working, possibly resulting in data loss.
The supplied power cord conforms to safety rules and
regulations in the region where the product was
purchased. Do not use the AC adaptor that was included
with your computer. Always use the Toshiba AC adaptor
that was provided with this product or use Toshiba
recommended alternate adaptors to avoid any risk of fire
and/or other damage to the computer and/or port
replicator. Use of an incompatible AC adaptor could
cause fire and/or damage to the computer and/or port
replicator, possibly resulting in serious injury. TOSHIBA
assumes no liability for any damage caused by use of an
incompatible adaptor.
When you connect the AC adaptor to the port replicator,
always follow the steps in the exact order as described
below. Connecting the power cable to a live electrical
outlet should be the last step, otherwise the adaptor DC
output plug could hold an electrical charge and cause an
electrical shock or minor bodily injury when touched. As
a general safety precaution, avoid touching any metal
parts.
Your port replicator will come with either a 2-pin or a
3-pin plug, depending on where it was purchased.
(Sample Illustration) Connecting the power cord to the AC
adaptor
1 Connect the provided power cord to the AC adaptor.
2 Connect the AC adaptor to the DC-IN (19V) connector
on the port replicator.
15