Fcc Information - Toshiba Hi-Speed ​​Port Replicator III Manual Del Usuario

FCC information

FCC notice "Declaration of Conformity
Information"
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
❖ Reorient or relocate the receiving antenna.
❖ Increase the separation between the equipment and
receiver.
❖ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
❖ Consult the dealer or an experienced radio/TV
technician for help.
FCC Conditions
This equipment has been tested and found to comply with
Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received,
including interference that may cause undesired
operation.
Only Peripherals complying with the FCC Class B limits
may be attached to this equipment. Operation with
noncompliant peripherals or peripherals not
recommended by Toshiba is likely to result in interference
to radio and TV reception. Shielded cables must be used
between the external devices and the replicator's ports.
7