Regulatory Statements; Working Environment - Toshiba Hi-Speed ​​Port Replicator III Manual Del Usuario

Regulatory statements

CE Compliance

Working Environment

❖ Industrial environment (e. g. where 3-phase 380V mains
is being used mainly): Danger of disturbances of this
product due to possible strong electromagnetic fields
especially near to big machinery or power units.
❖ Medical environment: The compliance to the Medical
Product Directive has not been verified by Toshiba,
therefore this product cannot be used as a medical
product without further verification. The use in usual
office environments e.g. in hospitals should be no
problem if there is no restriction by the responsible
administration.
❖ Automotive environment: Please search the owner
instructions of the related vehicle for advice regarding
the use of this product (category).
Never place your product where it will be exposed to
excess heat, such as in direct sunlight, an unventilated
vehicle or near a heater. This may result in a system
failure, malfunction, loss of data or damage to the
product.
Never place your product in a location where it will be
exposed to extremely low temperatures. This may result
in a system failure, malfunction or loss of data.
Never subject your product to sudden temperature
variations. This may result in condensation, causing a
system failure, malfunction or loss of data.
Never operate your product on AC power during a
thunderstorm. If you see lightning or hear thunder,
immediately turn off the product. An electric surge
caused by the storm may result in a system failure, loss
of data or hardware damage.
This product is CE marked in accordance with the
requirements of the applicable EU Directives.
Responsible for CE marking is Toshiba Europe
GmbH, Hammfelddamm 8,41460 Neuss, Germany.
A copy of the official Declaration of Conformity can
be obtained from following website:
http://epps.toshiba-teg.com.
5