Special Features - Toshiba Hi-Speed ​​Port Replicator III Manual Del Usuario

Special features

The port replicator supports the following power-saving
features, if they are available on your computer. Refer to your
computer documentation for details.
Feature
Wake On LAN
Wake Up (USB)
Setting up and using the port replicator
This chapter explains how to set up the port replicator and
dock/undock your computer.
To set up the port replicator, follow the steps below:
1 Turn off your computer.
2 Disconnect all cables/cords from your computer.
3 Connect your external devices to the appropriate ports
on the port replicator.
4 Connect the included AC adaptor to the port replicator.
The port replicator supports a maximum of two external
displays.
For each VIDEO panel, only one port can function at a
time.
The port priority (from high to low) in each panel:
❖ VIDEO 1 panel: DisplayPort; HDMI
❖ VIDEO 2 panel: DisplayPort, DVI-D port, RGB monitor
port.
Purpose
When a computer in sleep or hibernation mode is
connected to the port replicator, this feature turns on
the computer when a wake-up signal is received
from a connected LAN cable.
When a computer in sleep or hibernation mode is
connected to the port replicator, this feature turns on
the computer when a wake-up signal is received
from a device connected to a USB port.
Note: When the Wake Up (USB) feature is enabled
and the docked computer is in sleep or hibernation
mode, the computer's AC power light may be on or
off, depending on the computer model. In either
case, the computer will turn on when a wake-up
signal is received from a USB device.
Special features
®
port.
14