Descargar Imprimir esta página

Sauder Edge Water 409048 Instrucciones De Ensamblaje página 11

Centro de entretenimiento
Ocultar thumbs Ver también para Edge Water 409048:

Publicidad

6
Surface without TWIST-LOCK
Surface sans FIXATIONS TWIST- -LOCK
Superficie sin SUJETADORES TWIST- -LOCK
How to use the SAUDER
TWIST-LOCKR
FASTENER (Refer to the
enlarged diagram.)
1. Insert the dowel end of the
FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the
FASTENER must remain fully inserted
in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a
Phillips screwdriver as tight as possible.
- Fasten the SHELF (G) to the
UPRIGHTS (C and D). Tighten four
R
TWIST-LOCK
FASTENERS.
All manuals and user guides at all-guides.com
Finished edge
Chant fini
Borde con acabado
D
G
Unfinished surface
Surface non finie
Superficie sin acabado
R
FASTENERS
R
R
Utilisation de la FIXATION
TWIST- -LOCKR SAUDER
(Consulter le schéma agrandi.)
1. Insérer l'extrémité filetée de la
FIXATION dans le trou de la pièce
attenante.
REMARQUE : L'extrémité filetée de
la FIXATION doit rester complètement
insérée dans le trou de la pièce
attenante lorsque l'on bloque la
FIXATION.
2. Bien serrer la FIXATION à l'aide
d'un tournevis Phillips.
- Fixer la TABLETTE (G) aux
MONTANTS (C et D). Serrer quatre
FIXATIONS TWIST- -LOCK
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Attention
Ne pas relever l'élément dans sa position
verticale avant d'avoir fixé l'ARRIÈRE.
L'élément risque de s'effondrer.
Precaución
No coloque la unidad en posición
vertical hasta que se fije el DORSO.
La unidad podría caerse.
Finished edge
Chant fini
Borde con acabado
C
Cómo utilizar el SUJETADOR
TWIST- -LOCKR SAUDER
(Refiérase al diagrama ampliado.)
1. Inserte el extremo con cabilla del
SUJETADOR dentro del agujero de la
parte adjunta.
NOTA: El extremo con cabilla del
SUJETADOR debe quedarse
completamente insertado en el agujero de
la parte adjunta cuando se enclava el
SUJETADOR.
2. Apriete el SUJETADOR lo más
apretado posible con un destornillador
Phillips (cruz).
- Fije el ESTANTE (G) a los
R
.
PARALES (C y D). Apriete cuatro
SUJETADORES TWIST- -LOCK
R
.
409048

Publicidad

loading