Funtions And Cleaning; Start-Up; Stopping; Counter Function - Zummo Z06 Manual De Usuario

6. FUNTIONS AND CLEANING


It is advisable to turn the machine off at the mains before starting any cleaning processes.

Do not wash the machine using water jets and/or water at high pressure.

We recommend at least one daily clean of the components in the juice squeezing zone (cups,
squeezing balls, drip tray, filter, blade and cover), following the cleaning instructions.

The product provided by the machine is citrus juice with a pH level of 4.5, which is not considered
as being a potentially dangerous foodstuff.
6.1. START UP

Once the machine is turned on, the display will show a number between 1 and 50 or the letter C.
The number indicates the quantity of oranges to be squeezed and the letter C means that oranges
will be squeezed without interruption for approximately 30 minutes.

Depending on the number of oranges that you want to squeeze, keep pressing the SELECT button
and the number on the display will increase from 1 to 50, and then the letter C will appear
(1,2,3,..........48,49,50,C,1,2,3.....). If you keep the SELECT button depressed for more than 3
seconds, the number will decrease.

Perform this operation until the desired quantity appears.

Once a quantity is selected and an operation is performed, the machine will store this information
(even if it is shut off) until a new selection is made.

When the ON button on the panel is pressed, the machine will squeeze the number of oranges
shown on the display. During the process, the number of oranges left to squeeze will appear on the
display. If you want to repeat the operation, simply press the ON button. To stop the process, press
the STOP button.

6.2. STOPPING

With the machine running, press the StoP button. On the display a 0 will appear and the machine will
stop when the cups reach the vertical position. Afterwards, the display will show the number of the
previous selection.

6.3. COUNTER FUNCTION

If you want to know the total number of cycles* performed, press the STOP button while the machine
is not running and this number will appear on the display for a few seconds. Keep in mind that all
machines leave the factory with 400 – 500 cycles completed for quality control testing.
The display is limited to five digits, making it so a maximum of 99,999 cycles can be displayed. But if
you want to know the number of times that the counter has turned over, turn off the machine using the
power switch and turn it back on again while holding down the STOP button. The number that appears
is the number of times the counter has turned over.
*(Cycle = complete set of steps in squeezing a piece of fruit.)

6.4. CLEANING

We recommend that the squeezing area be cleaned on a daily basis.

It is recommended to halt the machine by pressing StoP before cleaning (never stop using the main
breaker switch), as in this way all the parts to be cleaned will be easily extractable and replaced.
Failure to follow this recommendation will cause the machine to stop in a position that impedes
cleaning and possibly lead to breakage of parts due to poor handling.
20