Safety Notes; Important Notes; Functions - marklin TRIX MINITRIX BR 111 Manual Del Usuario

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The wire used for feeder connections to the track may
only be a maximum of 2 meters / 78 inches long.
• Analog 15 volts DC, digital 22 volts AC.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
All manuals and user guides at all-guides.com
General Note to Avoid Electromagnetic Interference: A
permanent, flawless wheel-rail contact is required in order
to guarantee operation for which a model is designed. Do
not make any changes to current-conducting parts.

Functions

• Trix locomotives can be operated on all 2-rail DC systems
• Triple headlights in the front, dual red marker lights in the
• Trix motor vehicles must not be operated on digital
• Based on the NEM 661 standard, the speed of the loco-
• NEM close coupler mechanism and coupler pocket.
• Locomotive with a 14-pin digital connector.
• The light function can be changed by plugging
with conventional DC power packs.
rear, that change over with the direction of travel.
systems without an built in engine decoder (Motor can be
damaged!).
motive at 12 volts is set approximately at the maximum
speed for the prototype.
the bridge plug in the opposite way.
Double „A": switching light
LV+LR: headlight changeover front and rear
LV: headlight changeover only front
LR: headlight changeover only rear
5