Bosch SG45 Instrucciones De Funcionamiento Y Seguridad página 4

BM 2609932591 03-07
Never leave the trigger locked "ON".
Before plugging the tool in, check that the
trigger lock is "OFF". Accidental start-ups
could cause injury.
Position the cord clear of rotating driver.
Do not wrap the cord around your arm or
wrist. If you lose control and have the cord
wrapped around your arm or wrist it may
entrap you and cause injury.
Be aware of the location and setting of
the switch "Lock-ON" button. If the switch
is locked "ON" during the use, be ready for
emergency situations to switch it "OFF", by
first pulling the trigger then immediately
releasing it without pressing the "Lock-ON"
button.
Be prepared for a strong reaction torque
when "seating" or removing a screw. The
driver motor housing will tend to twist in the
opposite direction when "seating" or
removing a screw.
Do not use dull or damaged bits and
accessories.
Check to see that keys and adjusting
wrenches are removed from the driver
before switching the tool "ON". Keys or
TWIST-TO-LOCK CONNECTOR INSTRUCTIONS FOR MODEL SG45M-50 ONLY
The Model SG45M-50 is equipped with a
"Twist-To-Lock" male connector as shown. Use
only a 3-wire extension cord which has a mating
"Twist-To-Lock" female connector on one end
and a 3-prong grounding plug on the other end.
(See Electrical Safety section on page 2 for
grounding information.)
3/23/07 9:14 AM
20 AMP, 125 VOLT "TWIST-TO-LOCK"
Page 4
wrenches can fly away at high velocity
striking you or a bystander.
Do not run the tool while carrying it at
your side. A spinning drill bit could become
entangled with clothing and injury may result.
Some dust created by
!
WARNING
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
NEMA L5-20P
-4-