Tools required:
8
Attachment dimensions:
For upright/pendant mounting,
above/below bumper. Lamps
should neither vibrate nor extend
higher than the bonnet and must
be fitted symmetrically.
Page 3:
Mounting steps
• Ruler
• Combination pliers
• Pliers for crimp connectors
(if available)
C
D
Determine mounting position on flat
surface and mark mounting points.
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Preliminarily install mount.
Open housing and install bulb.
• 17 mm open end or box wrench
• Drill with 3, 5, 6, 11 and 12 mm
dia. bits
• 3 and 6 mm Allen keys
The table shows the possibilities
permitted in the various countries:
C
Do not touch bulbs with bare fingers!
Use tissue paper or similar.
Assemble housing.
Screw holder and housing together
and route cable cleanly.
Screw lamps to vehicle (use two-
point mount if required).
Align lamps and tighten screws.
(also see
"One more tip")