Nolan X-lite X-901 Instrucciones De Utilizacion página 23

If, during helmet use, or after replacing the visor, the visor is not
perfectly flush with the shell when closed, carry out the following
operations:
1) Press the red lever on the helmet chin guard and open the visor
all the way up.
2) When the visor opening red lever is up, work the adjusters to
move the release levers upwards (see Fig. 4a).
3) Check by slightly turning the visor down, then work the adjusters
4a
1 2
Warning! During adjustment, the arrows may not be aligned: it is
important that the position of the adjustment arrow 1 is not lower
than the adjustment arrow 2 (see Fig. 4a).
until the release levers are posi-
tioned as shown in Figure 3.
Push the red opening lever
upwards then release it: the
release levers must return to their
Fig. 3 position.
4) Close the visor and check that
the visor is flush with the shell.
Should it not be so, repeat the
operations in items 1, 2 and 3.
- 21 -