Nolan X-lite X-901 Instrucciones De Utilizacion página 24

1.4 - Visor removal
Perform the following operations on both sides of the helmet to
remove the visor:
1.4.1 - Open the visor all the way up (see 1.1).
1.4.2 - Press the visor spring pin (Fig. 5) towards the helmet inside
to release it, and simultaneously cause the visor to slide forwards in
its guides, until it comes off its side control (Fig. 6).
1.4.3 - Repeat the operations described in 1.4.2 on the other side.
5 6
Warning! Be careful not to loosen the adjustment screws on the
visor locking pins.
Maintenance and cleaning: Clean the mechanism of the visor
without altering it, by means of a little brush and compressed air.
If necessary, after removing dirt, lubricate moving parts with silicone
fluid or white Vaseline using a clean and soft cloth. Remove lubricant
in excess, if any.
1.5 - Visor mounting
To mount the visor back on to the helmet, the side controls should
be in their fully open positions. If it is not so, perform the following
operations on your visor-less helmet:
A) Push up the red opening lever on the helmet chin-guard (see Fig.
1 - 1.1.1).
- 22 -