Nolan X-lite X-901 Instrucciones De Utilizacion página 30

2.4 - Inner comfort padding fitting
To fit in the inner comfort padding, reverse the order of point 2.1.6
and 2.1.1 operations.
2.4.1 - Insert the chin paddings in the chin straps and fasten with the
end Velcro fastenings.
2.4.2 - Correctly insert the inner padding in the helmet.
2.4.3 - Insert the left chin strap in the special slot in the left cheek pad
(Fig. 17); do the same on the other side.
2.4.4 - Insert the left-hand and right-hand padding rear flaps in the
special frames in the nape area (see Fig. 16); to do this, gently work
the shell edge seal and push until you hear the locks go click.
2.4.5 - Insert the left-hand and right-hand cheek padding lower flaps
in the special frames in the cheek pad area inside the helmet (see
Fig. 15); to do this, gently work the shell edge seal and push in the
comfort padding.
2.4.6 - Insert the visor fixing front flaps into the shell support, by
gently pushing the liner towards the helmet inside (Fig. 14).
2.4.7 - Push one cheek pad towards the helmet inside at the height of
the three rear buttons, then do the same for the other cheek pad.
(Fig.13).
WARNING! If your helmet is equipped with the "D-Rings"
fastening system, fasten it according to the special instructions
(see "D-Rings" leaflet attached).
- 28 -