Nolan X-lite X-901 Instrucciones De Utilizacion página 27

Racing Comfort - Removable and washable inner liner
2.1 - Inner padding extraction
To remove the inner padding, carry out the following operations:
13
14
right-hand and left-hand rear flaps (Fig. 16) by gently working the shell
edge seal and pulling the nape comfort padding towards the inside.
2.1.5 – Release the left chin strap padding from its slot in the cheek
pad (Fig. 17); repeat the same operation for the right chin strap
padding.
2.1.6 – Extract the comfort padding from the helmet inside.
2.1.1 - Open the visor and undo
the chin strap, then remove one
of the cheek pads by pulling its
front end towards the inside of
the helmet, to snap open the
buttons on the pad rear end.
Repeat the same operations for
the other cheek pad. (Fig. 13).
2.1.2 – Release the front fixing
flap on the left-hand side from its support
in the inner shell, by gently pulling the lining
towards the inside of the helmet (Fig. 14),
then do the same for the front right-hand
flap and the central flap.
2.1.3 – Release the left cheek pad left-hand
bottom flaps from the helmet inside frame-
work (Fig. 15), by gently working the shell
edge seal and pulling the comfort padding
towards the inside. Repeat the same oper-
ations on the right-hand side and for the
other cheek pad.
2.1.4 – Similarly, release the framework
- 25 -