Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE BATTERY PACK: Depress the battery
release button as shown in figure C1 and pull battery
pack out of tool.
WARNING:
OPERATING INSTRUCTIONS
that conforms to ANSI Z87.1 (CAN/CSA Z94.3) while
operating this power tool.
NOTE: Before cutting any type of material, be sure it
is firmly anchored or clamped to prevent slipping.
• Place blade and shoe lightly against work to be cut.
• Switch on saw motor and allow it to obtain maximum
speed before applying pressure.
• Always hold saw firmly with both hands while cutting
as shown in figure D. Whenever possible, the saw
shoe must be held firmly against the material being
cut. This will prevent the saw from jumping or
vibrating and will minimize blade breakage.
The tool is equipped with a switch lock-off feature to
T T R R I I G G G G E E R R S S W W I I T T C C H H ( ( F F I I G G U U R R E E E E ) )
prevent unintentional operation.
• To switch the tool on, press the lock off button (2),
then squeeze the on/off switch (1).
• Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock the switch in
the ON position, and should never be locked in the ON
position by any other means.
WARNING:
BLADE CLAMP RELEASE LEVER
battery from tool before making any adjustments or removing or installing attachments
or accessories.
WARNING:
past the shoe and the workpiece during the cut. Increased risk of personal injury, as well as
damage to the shoe and workpiece may result.
1. Open blade clamp release lever to its full open
To install blade into saw:
position as shown in figure F.
2. Insert blade shank from the front.
3. Close blade clamp release lever. Check to make
sure blade is clamped securely.
NOTE: Blade can be installed upside-down to assist in
flush-to cutting.
WARNING:
TO REMOVE BLADE FROM SAW
Contact with the blade may result in personal injury.
1. Open blade clamp release lever to its full open position.
2. Remove blade.
Always use proper eye protection
Cut hazard. Turn off and remove
Cut hazard. Blade breakage may occur if the blade does not extend
Burn hazard. Do not touch the the blade immediately after use.
C1
D
E
F
9
2
1
Publicidad
Tabla de contenido
