Safety Instructions - Zanussi ZOB22601 Manual De Instrucciones

Internally the appliance becomes hot when in operation. Do not
•
touch the heating elements that are in the appliance. Always
use oven gloves to remove or put in accessories or ovenware.
Before maintenance cut the power supply.
•
Ensure that the appliance is switched off before replacing the
•
lamp to avoid the possibility of electric shock.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal scrapers to
•
clean the glass door since they can scratch the surface, which
may result in shattering of the glass.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
To remove the shelf supports first pull the front of the shelf
•
support and then the rear end away from the side walls. Install
the shelf supports in the opposite sequence.

Safety instructions

Installation
WARNING!
Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always wear
safety gloves.
• Do not pull the appliance by the handle.
• Keep the minimum distance from the other
appliances and units.
• Make sure that the appliance is installed
below and adjacent safe structures.
• The sides of the appliance must stay
adjacent to appliances or to units with the
same height.
Electrical connection
WARNING!
Risk of fire and electrical shock.
• All electrical connections should be made by
a qualified electrician.
• The appliance must be earthed.
www.zanussi.com
All manuals and user guides at all-guides.com
• Make sure that the electrical information on
• Always use a correctly installed shockproof
• Do not use multi-plug adapters and
• Make sure not to cause damage to the
• Do not let mains cables touch or come near
• The shock protection of live and insulated
• Connect the mains plug to the mains socket
• If the mains socket is loose, do not connect
• Do not pull the mains cable to disconnect
• Use only correct isolation devices: line
the rating plate agrees with the power
supply. If not, contact an electrician.
socket.
extension cables.
mains plug and to the mains cable. Should
the mains cable need to be replaced, this
must be carried out by our Authorised
Service Centre.
the appliance door, especially when the door
is hot.
parts must be fastened in such a way that it
cannot be removed without tools.
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
the mains plug.
the appliance. Always pull the mains plug.
protecting cut-outs, fuses (screw type fuses
3