Low Battery; Setting Up And Using The Tens One; Installation Of Batteries - TensCare Tens One Manual Del Usuario

if your body becomes used to the
sensation.
The orange LED on the output socket
indicates that there is an active output.
The LED will remain on as long as the
intensity is above 0.

LOW BATTERY

The LED indicator will flash
when you need to change
the batteries. The unit will
shut down about 2 minutes after this.
OPEN CIRCUIT CUTOUT
If the TENS One is not correctly
connected to your body, the strength in
the channel which is not properly
connected will automatically reset to
zero for 3 seconds and the display will
flash. After 3 seconds, the intensity will
start ramping back up to the intensity
selected. This also happens when
changing the mode. This is to prevent
sudden changes in sensations.
11. SETTING UP AND
USING THE TENS ONE
11.1. INSTALLATION OF
BATTERIES
1) Remove the battery cover.
2) Insert batteries.
Ensure that the batteries are inserted
the right way as shown in battery
compartment and that the ribbon is
behind them.
4) Replace the battery cover.
Caution: Remove batteries from your
TENS One if the unit is unlikely to be
used for a long period. Some types of
batteries may leak corrosive fluid.
Battery Life
Batteries should last at least 15 hours
at 50 mA, 300 μs, 50 Hz.
Unused batteries have a nominal shelf
life of 3 years, but will usually last longer
than this.
17