Preparation Of Coffee - Kalorik USK CM 32205 Manual De Instrucciones

Fax +1 305 430 9692
BEFORE FIRST USE
When you use your appliance for the first time, pour fresh water
•
into the water tank (without coffee) and switch on the appliance.
Once all the water has passed through, switch off the appliance
•
and let it cool down. When it is cold enough repeat the process 3
times with fresh water.

PREPARATION OF COFFEE

Open the lid of the water tank.
•
Pour the desired amount of water into the water tank. Make sure
•
not to overfill by respecting the maximum level indicated on the
water tank.
Place the filter holder into the coffee maker. Put a filter in the filter
•
holder and add the desired quantity of ground coffee in the filter.
Put back the filter holder, making sure it is placed correctly.
Never forget to close the lid of the water tank and to place the
•
glass carafe on the warming plate before switching on your
coffee maker.
Press the "power" button to switch on the coffee maker. The pilot
•
light will be illuminated, indicating that your appliance is working.
A device allows you to keep coffee warm for as long as the
coffee maker is working and the jug is standing on the appliance.
Caution: the coffee maker will not turn off as long as you don't
switch it off manually. We advise you not to let the appliance
switched on for more than 2 hours and make sure that you never
let an empty jug on the appliance;
When you remove the jug from the appliance, a non-drip valve
•
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the carafe automatically
opens the non-drip valve and allows remaining coffee to filter
trough into the jug.
Wait until the brewing process is finished and the filter has run
•
empty before removing the jug.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special instruction from Team
Print only
USK CM 32205 CM 32849 - 120501