WeatherTech Tailgate TechLiner Instrucciones De Instalación

Tailgate TechLiner
88TG16
1 1
Lower the tailgate and remove all tailgate accessories prior to
installation. Clean your truck bed and tailgate with soap and
water or TechCare® Gentle Car™ Shampoo and dry thoroughly
before installing the Tailgate TechLiner®.
3 3
While the Tailgate TechLiner® is flattening, use the enclosed
Torx bit to remove the 6 bolts from the tailgate as shown.
5 5
Unroll the extrusion and discard the plastic tube, being careful
not to kink the extrusion. Measure and cut off 3 inches of
the extrusion using sharp scissors or a utility knife. The short
section can be discarded. Place the extrusion against the
edge of the access panel with the opening facing the front of
the vehicle and centered on the tailgate. Slowly remove the
adhesive backing pressing firmly as you go.
®
Installation Instructions
2 2
Place Tailgate TechLiner® on a dry flat surface. Unfold and lay
out to flatten the liner. For best results, lay liner in the sun and
put a small weight on each of the corners. Locate the hook and
loop on the bottom of the Tailgate TechLiner® – keep the hook
and loop clean and do not remove the backing yet.
4 4
Prep the plastic area just above the access panel using the
alcohol wipe and let dry. Shake the Primer 94 and push the
center to crack open. Apply to the area the extrusion will
occupy and let stand for 5 minutes or until dry.
6 6
Lay the Tailgate TechLiner®, hook and loop facing down, onto
the tailgate making certain the features align. Do not remove
the plastic backing from the hook and loop at this time.
What You Need
¼" Drive Socket Set
or ¼" Wrench*
Sharp Scissors or
Utility Knife *
Parts Kit #88TG16
(1) T-30 ¼" Insert Bit
(2) Alcohol Wipes
(2) Primer 94
Also In Box
(1) Rolled Extrusion
*Not included