Festool TKS 80 EBS Control Del Funcionamiento página 4

SawStop AIM technology – Function monitoring
lights up
constantly
flashes slowly
lights up
constantly
off
flashes rapidly
(alternating)
flashes rapidly
lights up
constantly
flashes rapidly
off
flashes slowly
flashes slowly
lights up
constantly
off
lights up
constantly
flashes rapidly
off
flashes slowly
off
flashes slowly
flashes rapidly
off
flashes rapidly
flashes rapidly
lights up
constantly
|
English
www.festool.co.uk
The bench-mounted circular saw starts up in
approx. 10 seconds.
The bench-mounted circular saw is ready to use and is in
standby mode.
Restart protection
When activating bypass mode, the yellow SawStop AIM switch
was released too early.
› To rectify the fault, press the red STOP button.
Contact with the saw blade in standby.
› Remove the contact trigger and wait approx. 5 seconds
until the fault is rectified.
Or: Distance between saw blade and fence too small.
› When sawing cutting widths of ≤ 3 mm, use a support ≥ 19 mm.
Cartridge locking device fault.
› Switch off the bench-mounted circular saw and check
the cartridge locking device.
Saw blade missing or too small.
› Switch off the bench-mounted circular saw and insert
a suitable saw blade.
Replace the cartridge.
› Switch off the bench-mounted circular saw. If the fault is
still not rectified, insert a new cartridge.
Or: Electronics too cold: Warming phase at
ambient temperatures < 5 °C.
› Try starting again after a few minutes.
The saw blade comes to a stop.
The SawStop AIM technology is active and is triggered
upon contact.
Activated bypass mode.
Contact with the saw blade while bypass mode is activated.
The fault is rectified if the saw blade comes to a stop.
Workpiece too damp.
› Switch off the bench-mounted circular saw and dry the
workpiece or continue sawing in bypass mode.
The saw blade comes to a stop during sawing.
› Switch the bench-mounted circular saw off and on and saw
the workpiece more slowly.
Or: The bench-mounted circular saw is operational and
the yellow SawStop AIM switch has been pressed.
› Switch the bench-mounted circular saw off and on.