48 9.4.2 Measuring The Width - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

 The left display shows the currently set rim
width;
 The right display shows rim diameter.
i The displays do not show rim distance. Correct value
acquisition can however be verified using the keys
(cap 7.2).
i If electronic rim distance and diameter measure-
ment is not possible, wheel data can also be entered
manually.
i To enter the rim data manually, the electronic cal-
liper gauge must be deactivated.
i Contact the after-sales service to deactivate the
electronic calliper gauge.
i In order to enter rim distance and diameter manu-
ally, follow the procedure described here below.
2. Position the distance calliper gauge on the rim and
detect the value in position "K" on the millimetric
scale;
651076-16_Im
k
100
90 80 7 0 6 0 50 40 30 20 10
Fig. 48:
3. After pressing the "Distance" key
<+> to enter the rim distance value measured in "mm".
i The rim distance can be detected on the rim itself or
measured with a measurement compass.
Werther International S.p.A.
Balancing a wheel | MERCURE 200 | 65
Fig. 49:
3 Rim diameter scale
4 Outer tip for rim diameter
4. After pressing the "Diameter" key
to enter the rim width value measured in "inches".
i For certain types of rim, the width is given in "mm".
After changing the units with the appropriate key
(refer to Section 7.2), enter the value given in "mm".
9.4.2
1. The rim width can be read off the rim or determined
with the measuring compasses.
1
Fig. 50:
,, use <-> or
1 Rim width scale
2 Inner tip for rim width
2. After pressing the "Width" key
to enter the rim width value measured in "inches".
i For certain types of rim, the width is given in "mm".
After changing the units with the appropriate key
(refer to Section 7.2), enter the value given in "mm".
" All the required wheel data have been recorded.
Determining rim data with measuring compasses
Measuring the Width
2
651076-17_Im
Determining rim data with measuring compasses
1 695 109 017
en
, use <-> or <+>
, use <-> or <+>
|
2019-01-07