WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones página 74

en 76 | MERCURE 200 | Faults
Err Possible causes
21 The PCB has detected an excessively high wheel speed
with the wheel guard open (shaft rotating at high speed
although the machine has not been started): Power sup-
ply unit is deactivated
22 Irregular measurement sensor signals
EEE EEE 1. Two buttons are pressed at the same time.
23 Vernier caliper not in rest position
|
1 695 109 017 2019-01-07
Remedy
1. Switch off the MERCURE 200 .
2. Lower the wheel guard, switch the MERCURE 200
on again without moving the wheel.
If the error message persists, contact customer ser-
vice.
If the error message persists, contact customer ser-
vice.
1. Only press one button at a time.
If the error message persists, contact customer ser-
vice.
1. Move the vernier caliper to rest position.
2. Repeat the calibration of the electronic vernier cal-
iper.
If the error message persists, contact customer ser-
vice.
Werther International S.p.A.