Making Connections - Tascam CD-BT1MKII El Manual Del Propietario

Making connections

Connecting a bass guitar (BASS
IN)
BASS GUITAR
 Connect a bass guitar to the
IN jack.
 Set the BASS IN switch to either
PASSIVE or ACTIVE
the unit according to the type of
your bass guitar.
 The BASS IN jack of the CD-
BT1MKII accepts unbalanced
input signals. Use a ¼ inch mono
phone plug.
Adjusting the input level
Use the INPUT control to adjust the
level of the input signal from the
IN jack.
12
— TASCAM CD-BT1MKII
All manuals and user guides at all-guides.com
Inputting signals from external
devices (
 The
mini-jack plug (3.5mm).
 The input level at the
cannot be adjusted on the CD-
BT1MKII, so adjust the output
level on the external device you
have connected.
BASS
LINE OUT OF EXTERNAL DEVICE
at the side of
WARNING
NEVER connect a bass guitar amplifier to the
CD-BT1MKII's
damage your equipment if you do this.
BASS
)
LINE IN
jack accepts a stereo
LINE IN
LINE IN
BASS IN
jack, as you will
Adjusting the output level after
adding built-in effects
Press and hold down the
EDIT key to open the Effect menu, and
press the NEXT or
jack
and use the UP
LVL
set the output level between 0 and 64.
Adjusting mix balance between
bass guitar and CD
Press and hold down the
SETUP key to open the Setup menu,
and press either the
to choose . You can set the mix bal-
MIX
ance using values between B (Bass) 10
– B1, 0, C (CD) 1 – C10.
EFFECT/
PREV key to choose
and DOWN keys to
TUNER/
NEXT or PREV key