bosal 004-218 Instrucción De Montaje página 4

Points 7, 8 and 9 concern only 13-pin set
Connect white/brown lead to earth (for instance drill the 3mm hole and connect and fix the eyelet terminal with sheet me-
7.
tal screw; do not secure the hole with anti-corrosion remedy).
8. Draw forming end of bunch (blue
located below left rear lights):
a) Reversing lights lead (black
length,
b) Clip the cap enclosed at the end of the lead running from vehicle front and clip the end enclosed at the end of the
lead running from rear lights, place the screens enclosed and connect with suitable electric joints.
Trailer power supply:
9.
3-pin connector housing (yellow and white/brown cables) is provided for expanded socket functions. Put this part
of cable set behind the trim. To expand socket functions it is necessary to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth" part no. 015-069
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during instal-
lation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing de-
vice.
to right lights (in vehicles produced up to 1997, black/blue lead is
is located below rear lights. Cut and isolate it from both sides on ca 5 mm
part no. 014-169