Error Codes; Troubleshooting - Lacor 69352 Instrucciones De Uso Y Mantenimiento

ERROR CODE
The lid does not close tightly
E1
The seal is deformed/broken
Problem with the safety switch
E2
Problem on the circuit board
PROBLEM
The machine does Loose or damaged power cable
not turn on or damaged power outlet
ON/OFF switch turned off
The machine does The bag is not properly
not perform the positioned
vacuum process
The seal is dirty, broken or
damaged
A complete
The bag is perforated or poorly
vacuum has not
sealed to begin with
been created in
The surface and sealing pad is
the bag
wrinkled, there is some impurity
or leftover food
The sealing bar is dirty
The machine does
The seal is damaged and the
not go from the
unit does not reach the proper
vacuum to the
pressure
sealing process
The machine does
The sealing bar is broken
not seal
The bag is burned
The sealing bar is overheated
after the sealing
process
Air re-enters the
The bag is perforated. (be careful
bag after the
with foods that contain bones or
have sharp surfaces)
vacuum process
50

ERROR CODES

POSSIBLE CAUSE

TROUBLESHOOTING

POSSIBLE CAUSE
SOLUTION
Clean the seal of the lid and the
perimeter of the chamber
Request a replacement from the
manufacturer
Send the machine to a service
centre
Send the machine to a service
centre
SOLUTION
Connect the unit to a different
power outlet
Turn the switch to ON
Position the bag following the
instructions provided
Clean it or replace it if it is
broken
Change the bag
Clean the pad and begin a new
cycle
Clean the sealing bar
Clean the seal of the lid and the
perimeter of the chamber.
Replace it with a new one if
necessary
Request a replacement from the
manufacturer
Allow the unit to cool for a few
minutes before starting a new
cycle
Change the bag