How Your Icemaker Works - GE Monogram ZDI15 Guía De Uso Y Cuidado

How your
When you first start your icemaker, the water
pan will fill and the system will rinse itself
icemaker
before starting to make ice. The rinsing
works
process takes about five minutes.
Under normal operating conditions, the ice-
maker will cycle at preset temperatures. The
ice level sensor located in the ice storage bin
will monitor the ice levels.
IMPORTANT
•
•
The icemaker is designed to make clear ice
Making Ice
1. Water is constantly circulated over a freezing
2. When the desired thickness is reached, the
12
If the water supply to the icemaker is
turned off, be sure to set the icemaker
control to OFF.
from the majority of water sources on a daily
basis. If your results are unsatisfactory, your
water may need to be filtered or treated.
plate. As the water freezes into ice, the
minerals in the water are rejected. This
produces a clear sheet of ice with a low
mineral content.
ice sheet is released and slides onto a cutter
grid. The grid divides the sheet into
individual cubes.
Operating Instructions
Icemaker
3. The water containing the rejected minerals
is drained after each freezing cycle.
4. Fresh water enters the machine for the next
ice making cycle.
5. Cubes fall into the storage bin. When
the bin is full, the icemaker shuts off
automatically and restarts when more ice
is needed. The ice bin is not refrigerated
and some melting will occur. The amount
of melting varies with room temperature.
NOTE: As the room and water temperatures
vary, so will the amount of ice produced and
stored. This means that higher operating
temperatures result in reduced ice production.